Notes On User Account Name And Uid; New Proxyuser System Account; Xcp Issues And Workarounds; Known Issues And Workarounds In Xcp 1092 - Fujitsu Sparc Enterpise M8000 Product Notes

Notes on User Account Name and UID

If the Service Processor is configured to use Lightweight Directory Access Protocol
(LDAP), Active Directory, or LDAP/SSL for user account data, the user name and
UID (if specified) must not already be in use locally or in LDAP, Active Directory, or
LDAP/SSL.

New proxyuser System Account

To support Active Directory and LDAP/SSL, this release features a new system
account named proxyuser. Verify that no user account of that name already exists.
If one does, use the deleteuser(8) command to remove it, then reset XSCF before
using the Active Directory or LDAP/SSL feature.

XCP Issues and Workarounds

This section contains information about XCP issues.
issues you might encounter, depending upon which XCP release you are using.

Known Issues and Workarounds in XCP 1092

TABLE 4
Known Issues and Workarounds in XCP 1092
TABLE 4
ID Description
RTIF1- When you execute XCP Sync on the Firmware
070914-025 Update page, after 15 minutes, the error
message "Another flashupdate is now
processing" or "The page cannot be
displayed" may appear.
RTIF1- DR operations might fail (with a misleading
071116-001 message regarding the board being
unavailable for DR) after the addfru(8) or
replceafru(8) command have been used for
active replacement. This happens when the
active replacement is done without the
diagnostic test in the maintenance menu.
lists known XCP issues and possible workarounds in XCP 1092.
,
TABLE 4 TABLE 5
Workaround
No workaround is available. However, the
XCP Sync process has been continuously
executed. Check the XSCF update completion
message on the monitoring message to confirm
the completion of Sync process.
Do not fail to execute the diagnosis in the
maintenance menu of the addfru(8) or
replacefru(8) command. In case of missing
the diagnostic test in the maintenance menu of
the addfru(8) or the replacefru(8)
command, execute the testsb(8) command or
delete the CPU/memory board unit using the
deletefru(8) command and then retry the
addfru(8) command.
Information About Software
, and list
TABLE 6
31