Fujitsu SPARC Enterprise M3000 Product Notes page 50

XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1-
071011-001
RTIF1- O
071102-001
RTIF1- O O
071102-002
RTIF1- O
071116-001
RTIF1- O
071116-003
RTIF1- O
071116-004
RTIF1-
071116-005
34 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
M8000
M9000 Description
O When the server is being installed,
and the mainline switch is turned on
for the first time, these error messages
might be displayed:
XSCFU hang-up is detected
XSCF process down detected
DB synchronization timeout
O The XSCF firmware monitors itself
and if it detects any inconsistencies, it
forces an XSCF reboot.
O The snmp daemon might quit.
DR operations might fail (with a
misleading message regarding the
board being unavailable for DR) after
the addfru(8) or replacefru(8)
command have been used for active
replacement. This happens when the
active replacement is done without
the diagnostic test in the maintenance
menu.
O Using the XSCF Web, when you
selected [COD], codusage details
cannot be displayed correctly.
O When Internet Explorer 7 browser is
used, the License key deletion cannot
be executed on the BUI COD page.
O While system power on, when the
XSCF switching performed by
switchscf(8) command, PANIC
might be generated in XSCF before it
switches, and "SHUTDOWN timeout"
may be stored in the error log.
Workaround
Turn off the system AC power, then
turn it on again.
No workaround is available. Allow
the XSCF Unit to finish rebooting. It
returns to normal operation within
approximately 5 minutes.
To restart the snmp daemon, issue the
command setsnmp enable.
Do not fail to execute the diagnosis in
the maintenance menu of the
addfru(8) or replacefru(8)
command. In case of missing the
diagnostic test in the maintenance
menu of the addfru(8) or the
replacefru(8) command, execute
the testsb(8) command or delete the
CPU/memory board unit using the
deletefru(8) command and then
retry the addfru(8) command.
Use showcodusage(8) command to
display the cod usage.
Use deletecodlicense(8)
command to delete a license key. Or
use other browsers:
• Microsoft Internet Explorer 6.0
• Firefox 2.0 or later
• Netscape Navigator 7.1 or later
No workaround is available. This
message can be safely ignored.