Fujitsu SPARC Enterprise M3000 Product Notes page 57

XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O O
081006-004
RTIF1- O O
081006-005
RTIF1- O O
081006-006
RTIF1- O O
081006-007
RTIF1- O O
081006-011
RTIF1- O O
081016-001
RTIF1- O O
081016-003
M8000
M9000 Description
O During the firmware update, there
might be the following output
message and a XSCF panic might
occur.
kernel BUG in
jffs2_do_read_inode at
fs/jffs2/readinode.c:XXX!
O The network configuration on the
XSCF Web does not support the
function equivalent to the
setnetwork -r command. And
when you specified localhost or
localdomain to the host name or the
domain name, the error message
"SessionID has expired"
appears.
O The panic log on the XSCF Web might
not be displayed from the top of the
message.
O The password(8) command indicates
that the user operand is optional but
will fail if a user operand is not
included when other options are
specified.
O SNMP trap host configuration
changes are not valid until setsnmp
disable and setsnmp enable.
O Power failure at the commercial AC
supply connector to the UPS does not
send notification/send trap.
O In Internet Explorer 6 or 7, clicking on
the [Reset] button then the [OK]
button from the [Settings]-[Audit]-
[Add Policy] pop-up screen will log
the user out with message:
Error
Session Error
Session ID has been expired
Workaround
Reset XSCF and use the
flashupdate(8) command to retry
the firmware update.
Use the setnetwork -r command
on the XSCF shell.
When the output is insufficient,
execute the showlogs panic
command on the XSCF shell.
No workaround is available.
Specify the user operand to execute
the password(8) command when you
specify other options.
Modify the SNMP setting:
XSCF> setsnmp disable
XSCF> setsnmp enable
No workaround is available.
Log back into the browser interface
and use the [Backspace] key to clear
text in the [User] text box of the pop-
up screen instead of using the [Reset]
button.
Chapter 3 Information About Software 41