Notes on Power Consumption Monitoring
Function (M3000 Server)
The amount of power consumption might not be indicated correctly in the MIB
■
information, in the showenvironment power command output, and on the XSCF
Web in the following cases; and you should wait for one minute and check the
value again.
During the server powering on or powering off, or for a while after the power-
■
on or power-off complete
During the active replacement of power supply unit, or for a while after the
■
active replacement complete
The figures on the power consumption monitoring function represent the
■
dissipation power from the server. The figures of peripheral devices are not
included.
Notes on Airflow Indicator
The amount of exhaust air might not be indicated correctly in the MIB
■
information, in the showenvironment air command output, and on the XSCF
Web in the following cases; and you should wait for one minute and check the
value again.
During the server powering on or powering off, or for a while after the power-
■
on or power-off complete
During the active replacement of power supply unit, or for a while after the
■
active replacement complete
The figures on the airflow indicator represent the volume of air exhausted from
■
the server. The figures of peripheral devices are not included.
Notes on NTP Server
We recommend the domain to use the XSCF Unit as NTP server. In this case, pay
■
attention to the following points:
XSCF must be connected to an external NTP server.
■
When you connect one or more NTP servers in addition to XSCF, connect the
■
same NTP server as XSCF is using.
For details on NTP server, contact a service engineer. For details on NTP settings,
refer to the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF
User's Guide.
Chapter 2
XCP 1121 and XCP 1121-related Information
9