Fujitsu SPARC Enterprise M3000 Product Notes page 38

Known Issues and Workarounds in XCP 1121 (Continued)
TABLE 3-1
M4000
ID M3000 M5000
RTIF1- O O
141209-001
22 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
M8000
M9000 Description
O Suppose that the audit system is
configured so that writing to audit
records stops temporarily when the
audit trail reaches its full capacity. An
XSCF shell or XSCF Web operation at
this time may lead to an XSCF reset
due to the mistaken detection of one
of the following errors: "Hardware
access error." or "SCF panic
detected."
This problem occurs even when the
XSCF shell is automatically run
regularly to monitor the logical
domain status by using
PRIMECLUSTER software.
You can check the contents of the
currently set audit system by using
the showaudit(8) command. In the
following example, "Policy on
full trail" is "suspend,"
indicating that writing to the audit
record has been set to stop
temporarily. Also, "Audit space
free" is "0," indicating that the audit
trail has reached its full capacity.
[Example]
XSCF> showaudit all
Auditing: enabled
Audit space used: 4194304
(bytes)
Audit space free: 0 (bytes)
Records dropped: 0
Policy on full trail:
suspend
omitted
Workaround
Execute the setaudit -p count
command to configure the audit
system to delete new audit records
when the audit trail has reached its
full capacity. (Default).
[How to restore]
Perform the following procedure.
1. Perform login authentication using
the default user account.
2. Execute the restoredefaults
xscf command.
3. Execute the setaudit -p count
command to configure the audit
system to delete new audit records
when the audit trail has reached its
full capacity. (Default)