Replying To A Message Using An Analog Telephone Connected To An Asm; Removing Items From Your Message List - Nortel M7410 Installation And Maintenance Manual

• Press .
CALL
If you want to call your message center using a line other than the programmed line,
exit your message list and dial the message center telephone number using normal
dialing methods.

Replying to a message using an analog telephone connected to an ASM

On an analog telephone connected to an ASM
• Press
˚•flfi
user to the oldest message sender. (The message can originate from either the
designated direct-dial telephone or the internal voice mail system.)
If the analog telephone has the Message Reply Enhancement feature set to Yes, and
the sender is the designated direct-dial telephone, the message waiting indicator is
turned off automatically after the reply call is answered, no matter from where the
call is answered.
For analog telephones connected to an ASM, using the Message Waiting Reply
feature (
˚•flfi
Analog telephones connected to an ASM cannot retrieve external messages by
using the Message Waiting Reply feature (
messages, users must call back the external voice mail center to retrieve their
messages. When doing so, the message waiting indicator on the analog telephone is
turned off automatically.

Removing items from your message list

You can erase a message while you are viewing it in your message list. If the
message is from your message center, this only erases the message notification at
your telephone. You need to erase the message at your message center. Refer to
your message center documentation.
On a telephone with a one-line display
• Press
˙
On a telephone with a two-line display
• Press
ERASE
P0908510 Issue 02
. The system automatically retrieves and connects the
), retrieves only internal messages sent to the user.
Tip
If Enterprise Edge Voice Messaging is not installed, only the designated
direct-dial telephone can send messages to an analog telephone connected to
an ASM using ƒ⁄. The analog telephone can in turn invoke a
single digit access code to reach the designated direct-dial telephone and
retrieve messages.
If the designated direct-dial telephone of an analog telephone connected to an
ASM is changed, messages sent by the previous designated direct-dial
telephone are kept in the incoming message list of the analog telephone until
they are retrieved.
.
.
Enterprise Edge Feature Programming Telephone Guide
Communicating in the office 63
). For external
˚•flfi