Time savers for making calls
Storing a number on a memory button for Autodial
You can program memory buttons for one-touch dialing of internal or external
telephone numbers.
Buttons used for lines, answer or Handsfree/Mute cannot be used as autodial
buttons. If the power to your Enterprise Edge system is off for more than three days,
autodial numbers (as well as some other system programming) may be lost from the
memory.
Adding an autodial button
ƒ•⁄
1. Press
ƒ•⁄
internal number.
2. Choose a button and then enter the number as if you were dialing it.
When programming Autodial you can use:
•
Last Number Redial
•
Saved Number Redial
•
destination codes (choose
•
host system signalling
Choosing a line for Autodial
To include a line selection for an external number, press the line or intercom button
before you enter the number. To select a line pool, press a programmed line pool
button, or press
If you select a line before pressing the autodial button, the call goes out on the line
you have selected instead of the line that is part of the autodialer programming.
For the M7100 telephone, an external autodialer can be programmed only by using
a line and not a line pool.
P0908510 Issue 02
or
ƒ•¤
to program an external number or
∆
and enter a line pool access code.
∆
Tip
If you do not include a line selection in an autodial number, the call uses your
prime line (if you have one).
Enterprise Edge Feature Programming Telephone Guide
ƒ•¤
as the line)
4
for an