Using A Line Pool To Make A Call; Programming A Memory Button With A Line Pool Feature Code - Nortel M7410 Installation And Maintenance Manual

The Enterprise Edge system can have 15 line pools plus 6 PRI pools, and a
telephone can be programmed to access any number of them.
A line pool access code is a number you dial to get a line pool. The access code can
be up to four digits long. You can have several different line pools for your system,
each one giving you access to a different set of external lines. It is one way of
sharing lines across telephones in a system.
Your installer programs the line pool access codes and gives each telephone access
to a line pool.
Everyone in the office should have a list of the line pool access codes for the line
pools their telephones can use.

Using a line pool to make a call

ƒfl›
1. Press
ƒfl›
2. Enter a line pool access code.
If you have a free internal line, you can make a call using a line pool without
entering the feature code first.
1. Select an internal line (intercom).
2. Dial the line pool access code.

Programming a memory button with a line pool feature code

When you program a button with the line pool feature code, you must enter a line
pool access code after the feature code. The programmed line pool button accesses
a specific line pool, not the line pool feature. See
page 74 for more information.
If you program a button with an indicator to access a line pool, when all the lines in
a line pool are busy, the indicator for the line pool button turns on. The indicator
turns off when a line becomes available.
P0908510 Issue 02
.
Tip
If no lines are available in the line pool, you can use Ring Again at the busy
tone. You are notified when a line in the line pool becomes available.
See Using Ring Again on page 36.
Enterprise Edge Feature Programming Telephone Guide
Making calls 33
Programming feature buttons on