Figure 38 Multilink Trunk Configuration Screen For Switch S4 - Nortel BayStack 380 Using Manual

Figure 38

Figure 38 MultiLink Trunk Configuration screen for Switch S4

Switch S4 is configured as follows:
•
•
•
•
•
•
shows the MultiLink Trunk Configuration screen for Switch S4.
Trunk (read only) indicates the trunk (1 to 6) that corresponds to the switch
ports specified in the Trunk Members fields.
Trunk Members indicates the ports that can be configured, in each row, to
create the corresponding trunk.
— Ports 15 and 19 are assigned as trunk members of trunk T5.
STP Learning indicates the spanning tree participation setting for each of the
trunks. Trunk 1 is enabled for Normal STP Learning.
Trunk Mode (read only) indicates the Trunk Mode for each of the trunks. The
Trunk Mode field value for trunk 1 is set to Basic. Source MAC addresses are
statically assigned to specific trunk members for flooding and forwarding,
which allows the switch to stabilize and distribute the data streams of source
addresses across the trunk members.
Trunk Status indicates the Trunk Status for each of the trunks. When it is set
to Enabled, the configuration settings for that specific trunk are activated.
Trunk Name indicates optional fields for assigning names to the
corresponding configured trunks.
Chapter 2 Network configuration
Using the BayStack 380 10/100/1000 Switch
85