Table of Contents
Advertisement
Table 24 Port Configuration screen fields (continued)
Field
LnkTrap
Autonegotiation
Speed/Duplex
1
1 Fiber optic ports can only be set to 100 Mb/s/Half or 100 Mb/s Full.
Description
Allows you to control whether link up/link down traps are sent to the configured trap
sink from the switch.
Default Value
On
Range
On, Off
When enabled, sets the corresponding port speed to match the best service provided
by the connected station, up to 1000 Mb/s in full-duplex mode. This field is disabled
for all fiber optic ports.
Default Value
Enabled
Range
Enabled, Disabled
Allows you to manually configure any port to support an Ethernet speed of 10 Mb/s
100 Mb/s, in half- or full-duplex mode, or 1000 Mb/s in full-duplex mode. This field is
set (by default) to 1000 Mb/s, full-duplex for Gigabit ports only.
Default Value
1000Mbs/Full (when Autonegotiation is Disabled)
Range
10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/Full, and
1000 Mb/s in full-duplex mode.
Chapter 3 Using the console interface
Using the BayStack 380 10/100/1000 Switch
133
Advertisement
Table of Contents
