Table 37 Telnet Configuration Screen Fields - Nortel BayStack 380 Using Manual

Table 37

Table 37 TELNET Configuration screen fields

Field Description
TELNET Access Allows a user remote access to the CI through a Telnet session.
Default Value:
Range:
Login Timeout Specifies the amount of time a user has to enter the correct password at the
console-terminal prompt.
Default Value:
Range:
Login Retries Specifies the number of times a user can enter an incorrect password at the
console-terminal prompt before terminating the session.
Default Value:
Range:
Inactivity Specifies the amount of time the session can be inactive before it is terminated.
Timeout
Default Value:
Range:
Event Logging Specifies the types of events that will be displayed in the Event Log screen (see
Log screen" on page
Default Value:
Range:
Description:
describes the TELNET Configuration screen fields.
Enabled
Enabled, Disabled
1 minute
0 to 10 minutes (0 indicates "no timeout")
3
1 to 100
15 minutes
0 to 60 minutes (0 indicates "no timeout")
147.
All
All, None, Accesses, Failures
All: Logs the following Telnet events to the Event Log screen:
• TELNET connect: Indicates the IP address and access mode of a
Telnet session.
• TELNET disconnect: Indicates the IP address of the remote host
and the access mode, due to either a logout or inactivity.
• Failed TELNET connection attempts: Indicates the IP address of
the remote host whose IP address is not on the list of allowed
addresses, or indicates the IP address of the remote host that did
not supply the correct password.
None: Indicates that no Telnet events will be logged in the Event Log
screen.
Accesses : Logs only Telnet connect and disconnect events in the
Event Log screen.
Failures: Logs only failed Telnet connection attempts in the Event Log
screen.
Chapter 3 Using the console interface
Using the BayStack 380 10/100/1000 Switch
163
"System