Installing A Small Form Factor Pluggable Sfp Gbic; Figure 85 Inserting An Lc Sfp Gbic - Nortel BayStack 380 Using Manual

Appendix B Installing SFP and CWDM Gigabit Interface Converters (GBICs)

Installing a Small Form Factor Pluggable SFP GBIC

This section lists the steps to install an SFP GBIC.
To install an SFP GBIC:
1
2
3
4
5

Figure 85 Inserting an LC SFP GBIC

Note: When you contact a Nortel Networks service representative for
troubleshooting purposes, you must have the following information
available:
Remove the SFP GBIC from its protective packaging.
Verify that the SFP GBIC is the correct model for your network configuration
(Table 47 on page 183).
Remove the dust cover from the SFP GBIC's optical bores.
Grasp the SFP GBIC between your thumb and forefinger.
Insert the SFP GBIC into the slot on the front panel of the Gigabit Ethernet
switching module (Figure
• Nortel Networks serial number
• Manufacturer's code
• Interface type
• GBIC part number
86).
L in k
A c t
E M D A
0 0 -2 G
B P S 2 0
10521FA
Using the BayStack 380 10/100/1000 Switch
187