Fiat Bravo Service Manual page 793

Hide thumbs Also See for Bravo:

Table of Contents

1. Remove the stud shown in the figure and

move the lining of the bulkhead between

engine bay and passenger compartment

to one side.

2. Unscrew the bolt retaining the accelerator

cable ducting device, on the bulkhead be-

tween engine bay and passenger c o m -

partment. Also remove the underlying

rubber block in order to free the hole and

allow removal of the cable.

3. Release the accelerator cable from the re-

taining clip located beneath the injection

control unit.

4. Withdraw the cable through the hole in

the bulkhead between engine bay and

passenger compartment and remove from

the engine bay.

When refitting, adjust the cable as

described in the paragraph

ing throttle cable"in Section 10 "Fuel

system" for the left hand drive ver-

Publication no. 508.876