Fiat Bravo Service Manual page 442

Hide thumbs Also See for Bravo:

Table of Contents

NOTE If work has to be done on the rpm and TDC sensor mounting (e.g. gap outside tolerance limits,

sensor misaligned, etc.), the procedure must be carried out for correct positioning of the sensor

and its mounting, and setting its timing, as described in the engine overhaul manual (publica-

tion no. 504.589/20).

Bravo-Brava <0i 16v

Wiring connector

The sensor is connected to the control unit by

means of twisted cables covered by a shield-

ed anti-interference sheath.

Pin 1 - Signal

Pin 2 - Earth

Pin 3 - Shielding

NOTE The numbers in boxes indicate the

corresponding control unit pins.

Checking resistance

The sensor's resistance can be measured by

disconnecting the connector and connecting

an ohmmeter to the ends of the sensor.

Resistance 1134 -1386 ohm at 20 °C

Publication no. 506.670/14