Electrical equipment
Radio equipment
5 5 .
To recall transmitters programmed in the IS memory, select the IS operating mode by pressing one of the
" A " " T " buttons (2,3) for about 3 seconds until the message "IS - -" appears on the display, followed
by "IS O N " . By pressing one of the " A " " • " buttons briefly it is possible to recall the transmitters pro-
grammed.
To deactivate the IS function, press one of the " A " " T " buttons briefly until the message "IS OFF" appears
on the display.
66
Automatic intelligent search tuning
function)
Using the BN button (1), select the " F M 1 " ,
" F M 2 " or " F M 3 " band.
Press the BN button (1) for about 3 seconds
to activate the saerch; the message "LEARN"
will appear on the display.
At the end of the search first the RDS pro-
grammes and then the transmitters according
to their transmission power in the radio IS
memory are programmed. The IS memory
can store up to 30 transmitters.
If no reception is possible, the reception does
remain continuously activated; to interrupt it,
press one of the station selection buttons
(1,2,3,4,5,).
P4A66HL01
RDS transmitters automatic search tuning
Select the FM or A M frequency desired using
the BN button (1).
The IS function should not be activated for
this type of selection.
If the IS function is switched on, press either
button " A " (2) or " T " (3) for about 3 sec-
onds until the message "IS - -" appears on
the display followed by "IS OFF".
Pressing one of the buttons " A " (2) or " T "
(3) briefly starts the automatic search. When
a transmitter w i t h an identification code is
found (RDS transmitter) it is shown on the
display. If the transmitter is going to be pro-
grammed in a selector button (1,2,3,4,5),
press the pre-selected button for about 2 sec-
onds. The radio audio function will be inter-
rupted until the programming has been c o m -
pleted.
XI-98 - Update
Bravo-Brava
98 range
(IS
Print no. 506.670/77