Table of Contents
Advertisement
Link State
Active Member
Standby Member
Modify
4.4.3 LAG Port Setting
This page allows setting configuration for each LAG. The LAG Port Setting screens in
The page includes the following fields:
Object
LAG Selet
Enable
Speed
Flow Control
Display the link state
Display the active member
Display the standby member
Click
to modify LAG configuraiton
Figure 4-4-6 LAG Port Setting Information Page Screenshot
Description
Select LAG number from this drop-down list.
Indicates the LAG state operation. Possible states are:
Enabled - Start up the LAG manually.
Disabled – Shut down the LAG manually.
Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
Auto – Set up Auto negotiation.
Auto-10M – Set up 10M Auto negotiation.
Auto-100M – Set up 100M Auto negotiation.
Auto-1000M - Set up 1000M Auto negotiation.
Auto-10/100M – Set up 10/100M Auto negotiation.
10M – Set up 10M Force mode.
100M – Set up 100M Force mode.
1000M – Set up 1000M Force mode.
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
selected, that is what is used. The current RX column indicates whether pause
frames on the port are obeyed. The current TX column indicates whether pause
Figure 4-4-6
103
User's Manual of LRP-822CS
&
Figure 4-4-7
appear.
Advertisement
Table of Contents
