Lag Port Setting - Planet GS-4210-8UP2S User Manual

4.3.2.3 LAG Port Setting

This page allows setting configuration for each LAG. The LAG Port Setting screens in
The page includes the following fields:
Object

LAG Select
 Enable
 Speed
 Flow Control
Buttons
: Click to apply changes.
User's Manual of GS-4210-8UP2S/GS-4210-16UP4C/GS-4210-24UP4C
Figure 4-3-28 LAG Port Setting Information Page Screenshot
Description
Select LAG number for this drop down list.
Indicates the LAG state operation. Possible states are:
Enabled - Start up the LAG manually.
Disabled – Shut down the LAG manually.
Select any available link speed for the given switch port. Draw the menu bar to
select the mode.

Auto – Set up Auto negotiation.

Auto-10M – Set up 10M Auto negotiation.

Auto-100M – Set up 100M Auto negotiation.

Auto-1000M - Set up 1000M Auto negotiation.

Auto-10/100M – Set up 10/100M Auto negotiation.

10M – Set up 10M Force mode.

100M – Set up 100M Force mode.

1000M – Set up 1000M Force mode.
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner. When a fixed-speed setting is
selected, that is what is used. The current Rx column indicates whether pause
frames on the port are obeyed. The current Tx column indicates whether pause
frames on the port are transmitted. The Rx and Tx settings are determined by the
result of the last Auto-Negotiation. Check the configured column to use flow
control. This setting is related to the setting for Configured Link Speed.
Figure 4-3-28
118
& Figure 4-3-29 appear.