Table of Contents
Advertisement
4.16 Maintenance
Use the Maintenance menu items to display and configure basic configurations of the LRP Managed Switch. Under
maintenance, the following topics are provided to back up, upgrade, save and restore the configuration. This section has the
following items:
■ Factory Default
■ Reboot Switch
■ Backup Manager
■ Upgrade Manager
■ Dual Image
4.16.1 Factory Default
You can reset the configuration of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
to reset the configuration to Factory Defaults.
After the "Factory" button is pressed and rebooted, the system will load the default IP settings as follows:
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
。
To reset the LRP Managed Switch to the Factory default setting, you can also press the hardware reset
button on the front panel for about 10 seconds. After the device is rebooted, you can login the
management Web interface within the same subnet of 192.168.0.xx.
You can reset the configuration of the switch on this page.
You can restart the switch on this page. After restart, the switch will boot
normally.
You can back up the switch configuration.
You can upgrade the switch configuration.
Select active or backup image on this Page.
Figure 4-15-1 Factory Default Page Screenshot
Hardware Reset button
336
User's Manual of LRP-822CS
Figure 4-15-1
appears and click
Advertisement
Table of Contents
