Setting 100Base-Fx For Sfp Port (Sgs-6340-20S4C4X Only) - Planet SGS-6340-24T4S Quick Start Manual

7. Setting 100BASE-FX for SFP Port (SGS-6340-
20S4C4X Only)
The Managed Switch supports both 1000BASE-X and 100BASE-FX SFP
transceiver by manual setting and the default SFP port speed is set to 1000Mbps.
To establish the fiber connection with 100BASE-FX SFP transceiver, the following
command configuration is required:
SGS-6340-20S4C4X#config
SGS-6340-20S4C4X(config)#interface ethernet 1/0/1-20
SGS-6340-20S4C4X(config-if-port-range)#speed-duplex force100-fx
module-type auto-detected
SGS-6340-20S4C4X(config-if-port-range)#exit
SGS-6340-20S4C4X(config)#interface ethernet 1/0/21-24
SGS-6340-20S4C4X(config-if-port-range)#media-type fiber
SGS-6340-20S4C4X(config-if-port-range)#speed-duplex force100-fx
module-type auto-detected
SGS-6340-20S4C4X(config-if-port-range)#
Figure 7-1 Setting 100BASE-FX Screen
9