Table of Contents
Advertisement
VA
FLUID AND FILTER (Continued)
(4) Actuate the service brake. Start engine and let
it run at idle speed in selector lever position P .
(5) Shift through the transmission modes several
times with the vehicle stationary and the engine
idling
(6) Warm up the transmission, wait at least 2 min-
utes and check the oil level with the engine running.
Push the Oil Dipstick 8863A in up to the stop on the
electrohydraulic unit and pull out again, read off oil
level, repeat if necessary.
NOTE: The dipstick will protrude from the fill tube
approximately 75mm (3 inches) when installed.
(7) Check transmission oil temperature.
NOTE: The true transmission oil temperature can
only be read by a scan tool in REVERSE or any for-
ward gear position. (Refer to 21 - AUTOMATIC
TRANSMISSION- NAG1/TRANSMISSION TEMPERA-
TURE SENSOR/PARK-NEUTRAL SWITCH - OPERA-
TION)
cator marks every 10mm. Determine the height of
the oil level on the dipstick and using the height, the
transmission temperature, and the Transmission
Fluid Graph (Fig. 137), determine if the transmission
oil level is correct.
oil level.
stick tube cap (2) (Fig. 138) and lock pin (1).
STANDARD PROCEDURE - TRANSMISSION
FILL
change or overhaul, perform the following procedure:
face.
plate of the locking pin with a suitable tool and press
out the pin remaining in the cap downwards.
transmission:
Fig. 137 NAG1 Transmission Fill Graph
AUTOMATIC TRANSMISSION - NAG1 21 - 103
(8) The transmission Oil Dipstick 8863A has indi-
(9) Add or remove oil as necessary and recheck the
(10) Once the oil level is correct, install a new dip-
To avoid overfilling transmission after a fluid
(1) Verify that the vehicle is parked on a level sur-
(2) Remove locking pin (1) (Fig. 139). Remove the
(3) Remove cap (2).
(4) Add following initial quantity of Shell 3403 to
Advertisement
Table of Contents
