Table of Contents
Advertisement
VA
AUTOMATIC TRANSMISSION - NAG1 (Continued)
Fig. 27 Remove Shift Cable From Transmission
1 - SHIFT CABLE
2 - TRANSMISSION SHIFT LEVER
(d) Rotate engine by hand until bolts (2) (Fig.
29) are in front of opening. Rotate engine forwards
at crankshaft.
(e) To remove bolts, position a ratchet with long
extension and joint nut as shown (Fig. 30).
(f) Remove 3 x 2 bolts (2) (Fig. 29) at circumfer-
ence of driving plate.
Fig. 28 Lower Steering Gear
1 - STEERING GEAR
2 - BRACKET
(13) Support engine. Insert wooden block between
oil pan and front chassis crossmember beam.
(14) Remove vent hose bracket and tie back to one
side.
(15) Disconnect ground strap and tie back to one
side.
AUTOMATIC TRANSMISSION - NAG1 21 - 29
Fig. 29 Remove Torque Converter Access Cover
1 - TORQUE CONVERTER ACCESS COVER
2 - BOLT
Fig. 30 Remove Torque Converter Bolts
1 - BOLT
2 - STABILIZER BAR
3 - REINFORCEMENT PLATE
4 - OPENING
5 - CHASSIS CROSSMEMBER
6 - STEERING GEAR
(16) Remove bolts (A) (Fig. 31) on underside of
transmission. Two bolts (A) on top of transmission
must remain in the housing.
(17) Place
hydraulic
transmission and raise slightly. Secure transmission
on hydraulic jack with a strap or ask an assistant to
hold it.
transmission
jack
under
Advertisement
Table of Contents
