Mercedes-Benz 2005 Sprinter Service Manual page 999

VA
OUTPUT SHAFT BEARING (Continued)
Fig. 175 Slide Remover 9082 Collar Downward
1 - BEARING REMOVER 9082
2 - TRANSMISSION CASE
3 - COLLAR
4 - FINGERS
Fig. 176 Remove Output Shaft Bearing
1 - BEARING REMOVER 9082
2 - TRANSMISSION CASE
3 - OUTPUT SHAFT BEARING
AUTOMATIC TRANSMISSION - NAG1 21 - 123
(a) Using Bearing Installer 9287 (Fig. 177),
install the output shaft bearing into the transmis-
sion housing. The closed side of the plastic
cage must point towards the parking lock
gear.
(b) Install the retaining ring (Fig. 178). Ensure
that the retaining ring is seated correctly in the
groove.
(c) Check that there is no play between the bear-
ing and the retaining ring using feeler gauge.
(d) There must be no play between the retaining
ring and the bearing. If the ring cannot be
installed, a thinner ring must be used. If there is
play between the ring and the bearing, a thicker
ring must be installed. Retaining rings are avail-
able in thicknesses of 2.0 mm (0.079 in.), 2.1 mm
(0.083 in.), and 2.2 mm (0.087 in.).
Fig. 177 Install Output Shaft Bearing
1 - BEARING INSTALLER 9287
2 - BEARING
3 - TRANSMISSION CASE
(2) Install the output shaft washer onto the output
shaft.
(3) Install a new transmission rear seal into the
transmission case with Seal Installer 8902A (Fig.
179).
(4) Verify that the transmission is in PARK in
order to prepare for the installation of the output
shaft nut.
(5) Install the propeller shaft flange onto the out-
put shaft and install an new flange nut. Tighten the
flange nut to 120 N·m (88.5 ft.lbs.).
(6) Stake the output shaft nut to the output shaft
as follows.