Table of Contents
Advertisement
VA
REAR BUMPER - STEP
REMOVAL
(1) Remove rear fascia. (Refer to 13 - FRAME &
BUMPERS/BUMPERS/REAR FASCIA - REMOVAL)
(2) Remove frame bolts/nuts. (Fig. 3)
(3) Remove the remaining support bolts.
Fig. 3 REAR BUMPER STEP
1 - FRAME BOLTS/NUTS (2)
2 - BOLTS (4)
3 - BUMPER STEP
4 - REAR FASCIA
INSTALLATION
(1) Install bumper step and install support bolts.
(2) Tighten bolts to 38 N·m (28 ft. lbs.).
(3) Install frame bolts/nuts and tighten to 90 N·m
(66 ft. lbs.).
(4) Install fascia. (Refer to 13 - FRAME & BUMPERS/
BUMPERS/REAR FASCIA - INSTALLATION)
REAR FASCIA
REMOVAL
(1) Remove screws and remove reflectors. (Fig. 4)
(2) Remove fascia bolts.
(3) Release bumper support brackets clips below
end panel.
(4) Press dowel pins out of and remove four plastic
rivets connecting fascia to rear step, if equipped.
(5) Separate the corners of the fascia from the sup-
port brackets and remove fascia.
Fig. 4 REAR FASCIA
1 - FASCIA
2 - BOLTS
3 - TAB
4 - REFLECTOR
5 - SUPPORT BRACKET
INSTALLATION
(1) Install fascia and seat the corners over the sup-
port brackets.
(2) Seat bumper support brackets clips below end
panel firmly.
(3) Install the four plastic rivets to the bumper
step, if equipped.
(4) Install fascia bolts and tighten to 23 N·m (17
ft. lbs.).
(5) Install reflectors and reflector screws.
FRAME & BUMPERS 13 - 3
Advertisement
Table of Contents
