Table of Contents
Advertisement
VA
DRIVING CLUTCH K1 (Continued)
ASSEMBLY
(1) Install piston (6) (Fig. 76) in the outer multi-
ple-disc carrier (1). Check sealing rings (4 and 5),
replace if necessary. The rounded off edges of the
sealing rings must point outwards.
(2) Insert disc spring (7) (Fig. 76). Insert disc
spring with the curvature towards the piston.
(3) Insert spring plate (8). Insert spring plate with
the curvature towards the sun gear. Check sealing
ring (9), replace if necessary.
(4) Place Multi-use Spring Compressor 8900 on
spring plate (8) and compress the spring until the
groove of the snap-ring is exposed.
1 - K1 OUTER DISC CARRIER
2 - FREEWHEELING CLUTCH F1
3 - SNAP-RING
4 - OUTER DISC CARRIER SEALING RING
5 - PISTON SEALING RING
6 - PISTON
check snap-ring for correct seat
NOTE: Pay attention to sequence of discs. Place
new friction multiple-discs in ATF fluid for one hour
before installing.
tiple-disc carrier.
Fig. 76 Driving Clutch K1 Components
7 - DISC SPRING
8 - SPRING PLATE
9 - SPRING PLATE SEALING RING
10 - SNAP-RING
11 - SNAP-RING
12 - MULTIPLE DISC PACK
AUTOMATIC TRANSMISSION - NAG1 21 - 75
(5) Insert snap-ring (10) (Fig. 76). After installing,
(6) Insert multiple-disc pack (12) in the outer mul-
(7) Insert snap-ring (11).
(8) Measure the K1 clutch pack clearance.
Advertisement
Table of Contents
