Table of Contents
Advertisement
21 - 100
AUTOMATIC TRANSMISSION - NAG1
ELECTROHYDRAULIC UNIT (Continued)
INSTALLATION
(1) Position the electrohydraulic unit in the trans-
mission housing.
(2) Insert selector valve (1) (Fig. 130) in driver of
detent plate (2). When installing the electrohydraulic
control module in the transmission housing, the plas-
tic part of the selector valve (1) must engage in the
driver of the detent plate (2).
Fig. 130 Connect The Selector Valve To The Detent
1 - SELECTOR VALVE
2 - DETENT PLATE
(3) Install the Torx socket bolts (3) (Fig. 131) and
torque to 8 N·m (71 in.lbs.).
(4) Install a new oil filter (4) (Fig. 131).
(5) Install oil pan (5) (Fig. 131) and torque the oil
pan bolts to 8 N·m (71 in.lbs.).
(6) Install the oil drain plug (8) (Fig. 131) with a
new drain plug gasket (9). Torque the drain plug to
20 N·m (177 in.lbs.).
(7) Install the guide bushing (2) (Fig. 131) into the
transmission housing and install the bolt to hold the
guide bushing in place.
(8) Check O-ring on plug connector (1) (Fig. 132),
and replace if necessary.
(9) Install the plug connector (1) into the guide
bushing (2). Turn bayonet lock of guide bushing (2)
clockwise to connect plug connector (1).
(10) Position the heat shield (2) (Fig. 133) onto the
transmission housing and install the screw (1) and
bolt (3) to hold the shield in place.
(11) Check oil level in automatic transmission, or
add oil.
Plate
Fig. 131 Remove Electrohydraulic Unit
1 - HEAT SHIELD
2 - ELECTROHYDRAULIC UNIT
3 - BOLT
4 - OIL FILTER
5 - OIL PAN
6 - CLAMPING ELEMENT
7 - BOLT
8 - DRAIN PLUG
9 - DRAIN PLUG GASKET
10 - 13-PIN PLUG CONNECTOR
11 - BOLT
12 - GUIDE BUSHING
Fig. 132 Install Wiring Connector Plug
1 - PLUG CONNECTOR
2 - GUIDE BUSHING
VA
Advertisement
Table of Contents
