Mercedes-Benz 2005 Sprinter Service Manual page 986

21 - 110 AUTOMATIC TRANSMISSION - NAG1
GEARSHIFT CABLE (Continued)
Fig. 148 Remove Shift Cable From Transmission
1 - SHIFT CABLE
2 - TRANSMISSION SHIFT LEVER
(a) Push shift cable onto the transmission shift
lever ball socket.
(b) Latch ball socket latch of cable.
(c) Clip shift cable retainer into retainer bracket.
Fig. 149 Install Shift Cable Onto Transmission
1 - SHIFT CABLE
2 - TRANSMISSION SHIFT LEVER
(3) Lower vehicle.
(4) Install the transmission shift cable onto the
ball knob at the SLA.
(5) Install the bottom section (2) (Fig. 150) of the
center section of instrument panel.
(6) Install the top section (3) (Fig. 151) of the cen-
ter section of instrument panel.
(7) Verify repair.
Fig. 150 Install Bottom Section Of Center
Instrument Panel
1 - SCREW
2 - BOTTOM CENTER PART OF INSTRUMENT PANEL
Fig. 151 Install Top Section Of Center Instrument
1 - SHIFT LEVER ASSEMBLY FRAME TRIM
2 - STORAGE COMPARTMENT
3 - TOP CENTER PART OF INSTRUMENT PANEL
4 - SCREW
5 - PLUG CONNECTIONS
6 - ASHTRAY
Panel
VA