RST mille
USA
7.1.48 COMPLETELY REMOVING THE GEARSHIFT
LEVER
WARNING
Before removing the gearshift lever, mark both the
lever and shaft so that you can place them correctly
when reassembling.
Place the vehicle on the center stand.
Remove the left lower fairing, see 7.1.33 (REMOVING
THE LOWER FAIRING).
Loosen the screw (1) and slide out the jaw (2) from the
gearbox pivot.
Tightening torque for screws (1): 7.3 ftlb (10 Nm).
Unscrew and remove the pin (3) retrieving the washer
(4).
Slide the gearshift pedal (5) out from the side,
complete with rods.
NOTE
Also replace the individual elements if
necessary.
Release 00/2002 - 03
1
2
5
2
CHASSIS
3
4
3
5
7
- 39 -
00