Removing The Air Filter Case - APRILIA RST mille Futura 2001 Service Manual

RST mille
USA

7.1.8 REMOVING THE AIR FILTER CASE

Carefully read 1.3.9 (PRECAUTIONS AND GENERAL
INFORMATION).
Remove the air filter, see 2.10 (AIR FILTER).
Release the clamp (1) and disconnect the hose (2).
Release the two clamps (3) and pull out the two lines
(4)
Unscrew the six screws (8).
Tightening torque for screws (8): 5.2 ftlb (7 Nm).
Raise the filter case (9).
Release the clamp (5) and disconnect the hose (6).
Disconnect the electrical connector (7) from the step
motor.
WARNING
When reassembling,
connector is fitted properly.
Remove the filter case (9), complete with intake
manifold (10).
NOTE
Plug the openings with a clean rag to prevent
any foreign matter from entering the air passages.
The intake manifold (10) must be positioned correctly and
aligned perfectly with the air intake holes in the frame.
Make sure that the air filter case (9) rests snugly against
the throttle body, and that it is correctly inserted into the
intake manifold (10). Only then should the screws (8) be
torqued, and the clamp (11) tightened.
If you remove the two air inlet ducts (12), make sure the
two O-rings are correctly positioned to prevent any
foreign matter from entering the engine.
Release 00/2002 - 03
make sure the electrical
2
1
6
9
12
8
11
CHASSIS
4
7
3
5
8
12
8
10
7
- 11 -
00