Electrical Connectors; Fasteners Tightening Torques - APRILIA RST mille Futura 2001 Service Manual

GENERAL INFORMATION

1.3.10 ELECTRICAL CONNECTORS

The electrical connectors must be disconnected as
follows. Failure to follow these procedures will irreparably
damage the connector and wiring.
Press in the click tab.
WARNING
Do not pull the cables to disconnect the two
connectors.
Grasp the two connectors and disconnect them by
pulling in opposite directions.
If dirt, rust, dust, or moisture is seen on the connector,
blow out the connector with air.
Ensure that the cables are correctly crimped to the
terminals placed inside the connectors.
NOTE
The two halves of the connector fit toghether
properly in only one orientation. Ensure that the
connector is properly aligned before attempting to
assemble it.
Press the connectors firmly together, listening for the
typical "click" sound for those connectors provided with
a click tab. Ensure that both halves of the connectors
are firmly pressed together.

1.3.11 FASTENERS TIGHTENING TORQUES

DANGER
Remember that the tightening torque of all fasteners
on the wheels, brakes, axles, and other components
of the suspension system is very important to ensure
the safety of the vehicle, and must be kept at the
prescribed values.
Check the tightening torque of the fasteners
regularly, and always use a torque wrench when
reinstalling them.
Failure to comply with this warning could allow one
of these components to be lost which could allow
one of these components to be lost which could lock
a wheel or cause other handling problems with
consequent overturning and risk of serious injury or
even death.
1
- 6 -
00
RST mille
USA
Release 00/2002 - 03