APRILIA RST mille Futura 2001 Service Manual page 44

GENERAL INFORMATION
NOTE
If using application tape (5)
20-30 minutes after applying the transfer.
Remove the application tape (5) from the transfer
surface.
To ensure good adhesion, move the spatula over
the transfer again, concentrating in particular on the
edges and corners.
NOTE
When transfers are applied wet, the glue is
not fully set for about 48 hours.
Once you have removed the application tape, make
sure there are no air bubbles on the surface.
If you do find surface air bubbles:
Use a pin or hobby knife (6) to puncture the edge
(7) of the air bubble.
With the spatula (1), start from the side opposite the
hole and scrape the bubble to allow any remaining
air to escape.
* Application tape is used to facilitate the application of
trademarks and letters, arranging them as desired on
the surface to be decorated, and to add extra firmness
to the adhesive backing during application.
1
- 34 -
00
* ,
it must be removed
RST mille
5
6
7
Release 00/2002 - 03
USA