20
INSTALLATION WARNING – Remote Synchronization
At this time we highly recommend you verify the remote and wireless wall switch are synchronized.
This process requires access to the receiver module – a component that is easily accessed when
the side of the fireplace is exposed. See the instructions on page 21 for details.
Battery Installation
This fireplace requires batteries for the remote, wireless wall switch, and battery box. We
recommend the batteies be replaced every year to insure proper operation. Follow the directions
below to install.
(make sure this switch is
set to "DC Motor Drive")
The Wall Switch requires two (2)
CR2032 3V batteries (included)
CR2032
Travis Industries
Installation
Battery Pack
Wireless Wall Switch
CR2032
(for qualified installers only)
The battery pack requires
four (4) AA batteries.
The Remote requires two (2) AAA batteries (included)
Cover Plate
(snaps into place)
Back of Remote
4060623
Figure 15
100-01170