Head Restraints - Skoda 2011 Yeti Owner's Manual

68 Seats and Stowage

After the successful assignment, the turn signal lights flash and an audible
signal will sound as a confirmation. The setting is stored with the memory button
which you have selected.
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the memory buttons
or with the remote control.
Retrieving settings with memory buttons
– In order to retrieve the stored setting, you have two possibilities:
– By pressing briefly: briefly press the desired memory button
fig. 59. The seat and exterior mirror are moved automatically into the stored
positions (this applies only if the ignition is switched on and the speed is less
than 5 km/h).
– By pressing for a long period of time: press and hold the desired memory button
A
pressed long enough until the seat and the exterior mirrors are moved into
B
the stored positions.
Retrieving settings with remote control
– If the driver door is closed and the ignition is switched off, briefly press the
unlock button of the remote control  page 41 and then open the driver door.
– The seat and exterior mirrors now move automatically into the stored positions.
Retrieving setting of exterior mirror for reversing
– Turn the rotary knob for the exterior mirror setting into the position
before engaging the reverse gear.
The mirror returns into its initial position, after the rotary knob is moved out of the
position  and put into another position or if the speed is more than 15 km/h.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.

Head restraints

A  page 67,
B
Fig. 60 Head restraint: Adjusting/pulling out
Best protection is achieved if the top edge of the head restraint is at the same level
as the upper part of your head.
Adjusting the height of a head restraint
– Grasp the side of the head restraint with both hands and push it in upward direc-
tion as desired
– Move the head restraint downwards if required by pressing and holding the
safety button with one hand
hand the head restraint downwards.
Removing and installing a head restraint
– Pull the head restraint out of the seat backrest as far as the stop.
 page 62

– Press the locking button in the direction of arrow
head restraint out.
– To re-insert the head restraint, push it down into the seat backrest far enough
until you hear the locking button engage.
The position of the front and rear outer head restraints is adjustable in height. The
middle rear head restraint is adjustable in two positions.
The head restraints must be adjusted to match the size of the seat occupant.
Correctly adjusted head restraints together with the seat belts offer effective
protection for the occupants  page 134, "Correct seated position".
 fig. 60
- left.
 fig. 60
- right and by pressing with the other
 fig. 60 - right and pull the