Skoda 2011 Yeti Owner's Manual page 68

Storing setting
Storing seat and exterior mirror settings for driving forward
– Switch on the ignition.
Adjust the seat  page 66.
–
Adjust both exterior mirrors  page 62.
–
A  fig.
– Press button SET
A
– Press one of the memory buttons
button SET - an acknowledgement signal confirms that the seat setting is
stored.
Storing exterior mirror setting for reversing
– Switch on the ignition.
– Turn the exterior mirror control to position
– Engage reverse gear.
– Move the right exterior mirror into the desired position  page 62.
– Take the vehicle out of gear. The set position of the exterior mirror is stored.
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the three
A  fig.
memory buttons 59, that is three in total. After pressing the corre-
B
A
sponding memory button , the seat and the exterior mirror are automatically
B
moved into the positions which have been allocated to this button  page 67.
Using the system Safety
Fig. 59 Driver seat: Memory buttons and
SET button
59.
A
within 10 seconds after pressing the
B
 page 62.

Driving Tips
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
Note

For safety reasons, it is not possible to store this position if the inclination angle
of the seat backrest is more than 102° in relation to the seat cushion.

When storing settings with the memory buttons, we recommend that you begin
with the front button and assign a memory button to each additional driver.

Each new setting stored with the same button erases the previous setting.

Each time you store the seat and exterior mirror settings for driving forward you
also have to re-store the individual setting of the exterior mirror on the passenger
side for reversing.
Assigning the remote control key to the memory buttons
After storing the settings of the seat and exterior mirrors, you have 10 seconds in
order to assign the remote control to the appropriate memory button.
– Withdraw the ignition key.
– Press the unlock button  page 41, after the successful assignment an audible
signal will sound. The setting is stored with the memory button which you have
selected.
If you wish to be able to retrieve the settings which are stored in the memory by also
using the remote control, you have to assign the remote control to a memory button
in each case.
If you wish, you can obtain an additional remote control key from an authorised
Škoda Service partner and then assign the remote control key to another memory
button.
Note

If the remote control had previously been assigned to another memory button,
this setting is then erased by the new assignment.

If you assign the remote control to a memory button which has already been
assigned to a remote control, the old assignment is also replaced by a new assign-
ment in this case.

The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.
General Maintenance Breakdown assistance
Seats and Stowage 67
Technical data