Skoda 2011 Yeti Owner's Manual page 77

76 Seats and Stowage
– Fold the slackened front part of the luggage compartment cover over the head
restraints of the rear seats.
– Slightly tilt the luggage compartment cover and remove it to the rear.
– Install again by pushing the luggage compartment cover forwards into the
holder A and hanging the support straps
2
You can stow the removed luggage compartment cover behind the rear seat back-
rest.
WARNING
No objects should be placed on the luggage compartment cover, the vehicle
occupants could be endangered if there is sudden braking or the vehicle collides
with something.
Caution
Please ensure that the heating elements of the rear window heater are not
damaged as a result of objects placed in this area.
Note
Opening the tailgate also lifts up the luggage compartment cover.
Static separation net
Fig. 75 Use of the static separation net behind the rear seats/behind the front seats
Install the static separation net behind the front seats or the rear seats.
A on the boot lid.
1
Install the static separation net behind the rear seats
– Remove the luggage compartment cover  page 75.
– Take the separation net out of the bag.
– Unfold both parts of the cross rod until they are heard to engage.
– Insert the cross rod into the mount
the cross rod forward. In the same way, fix the cross rod to the other side of the
A
vehicle, mount .
B
A
– Hang the carabines at the ends of the strap into the fixing eyes behind the
C
rear or front seats.
– Pull the strap through the tensioning clasp, first of all on the one side and then
on the other side.
Remove the static separation net behind the rear seats
– Slacken the bands on both sides and take off the carabines
– Push the cross rod first of all on the one side and then on the other side towards
the rear.
– Take the cross rod out of the mounts
Pack static separation net
– Press the red button of the joint
– Put the separation net folded together in the bag and close it.
– Attach the bag with the aid of the plastic carabines to the eyes on the left and
right luggage compartment trim panel.
Installing and removing the static separation net behind the rear seats with variable
loading floor  page 77 is carried out analogously as behind the rear seats without
variable loading floor. Use the lower fixing eyes on the carrier rails in order to attach
the carabines.
A  fig. 75
The opening in the separation net is designed to feed through the
D
three-point seat belt  page 140.
A  fig. 75
first on the one side and push
B
A  fig.
C
A
.
B
A
- so that it releases.
A
75.