How Are Seat Belts Correctly Fastened - Skoda 2011 Yeti Owner's Manual

How are seat belts correctly fastened?

Fastening three-point seat belts
Fasten your seat belt before starting!
Fig. 131 Routing of belt webbing for an expectant mother/routing of belt webbing over the
shoulders and the lap belt
– Correctly adjust the front seat and the head restraint before fastening your seat
belt  page 68, "Head restraints".
– Slowly pull the belt webbing at the tongue of the lock over your chest and pelvis
 .
– Insert the tongue of the lock into the seat belt buckle belonging to the seat until
it is heard to lock in place.
– Pull on the seat belt to check that it has also reliably engaged in the lock.
Each three-point seat belt is equipped with an inertia reel. This inertia reel offers
you complete freedom of movement if the belt is unreeled slowly. If the brakes are
applied suddenly, the inertia reel will block. The belts also block when the car accel-
erates, when driving downhill and when cornering.
Expectant mothers must also wear the seat belt 
WARNING

The shoulder part of the seat belt must never run across your neck but must
run approximately over the middle of the shoulder and fit snugly against the
chest. The lap part of the belt must run across the hip and must never be routed
across the stomach. It must always fit snugly
belt webbing as required.
Using the system Safety
.
 fig. 131 on the right. Adjust the
Driving Tips
WARNING (continued)

The lap part of the belt should be positioned as low as possible at the pelvis
of an expectant mother in order to avoid exerting any pressure on the lower
abdomen  fig. 131 - left.

Always ensure that the webbing of the seat belts is properly routed. Seat
belts which are not correctly adjusted can themselves cause injuries even in
minor accidents.

A seat belt which is hanging too loose can result in injuries as your body is
moved forward by the kinetic energy produced in an accident and is then
suddenly held firm by the belt.

Only insert the lock tongue into the lock which is the correct one for your
seat. This will affect the protection which the belt offers and increase the risk of
an injury.
Seat belt height adjuster on the front seats
The seat belt height adjuster makes it possible for you to adapt the routing of the
front three-point seat belt in the area of the shoulder to match your body size.
– Move the height adjuster in the desired direction up or down
– Then pull firmly on the belt to ensure that the seat belt height adjuster has
correctly locked in place.
WARNING
Adjust the height of the belt in such a way that the shoulder part of the belt is
positioned approximately across the middle of your shoulder - on no account
across your neck.
General Maintenance Breakdown assistance
Seat belts 139
Fig. 132 Front seat: Seat belt height
adjuster
 fig. 132.
Technical data