Digital Clock; Shift Recommendation For Changing Gears - Skoda 2011 Yeti Owner's Manual

18 Instruments and warning lights
The following will be displayed in the information display for 10 seconds:
Service after ... km or... days. (Service after ... km or ... days.)
Resetting Service Interval Display
It is only possible to reset the Service Interval Display, if a service message or at
least a pre-warning is shown on the display of the instrument cluster.
We recommend having this resetting performed by a specialist garage.
The specialist garage:

resets the memory of the display after the appropriate inspection;

makes an entry in the Service Schedule;

affix the sticker with the entry of the following service interval to the side of the
dash panel on the driver's side.
Reset the service interval displays by using the reset button
the trip counter.
On vehicles which are equipped with an information display, you can call up this
display in the menu Settings  page 24.
Caution
We recommend that you do not reset the Service Interval Display yourself other-
wise this can result in the service interval display being incorrectly set, which may
also result in problems with operation of your vehicle.
Note

Never reset the display between service intervals otherwise this may result in
incorrect readouts.

information is retained in the Service Interval Display also after the battery of
the vehicle is disconnected.

If the instrument cluster is exchanged after a repair, the correct values must be
entered in the counter for the Service Interval Display. This work is carried out by a
specialist garage.

The data displayed is the same after resetting the display with flexible service
intervals (QG1) is displayed as that for a vehicle with fixed service intervals (QG2). We
therefore recommend having the Service Interval Display reset only by an author-
ised Škoda Service Partner who is familiar with the procedure for resetting the
display with a vehicle system tester.

Please refer to the brochure Service schedule for extensive information about
the service intervals.

Digital clock

The time is set with the buttons
Select the display which you wish to change with the button
change with the button
On vehicles which are fitted with the information display, it is possible to set the
time in the menu Time  page 24.
WARNING
The clock should not be adjusted while driving for safety reasons but only when
the vehicle is stationary!
A  page 15, fig. 15
on
7

Shift recommendation for changing gears

An information for the engaged gear
instrument cluster.
In order to minimise the fuel consumption, a recommendation for shifting into
another gear is indicated in the display.
If the control unit recognises that it is appropriate to change the gear, an arrow
is shown in the display. The arrow points up or down, depending on whether it is
recommended to shift into a higher or lower gear.
At the same time, the recommended gear is indicated instead of the currently
engaged gear
A  page 15, fig. 15
3
A
.
7
Fig. 17 Recommendation for changing
gears
A  fig. 17 is shown in the display of the
A
A
.
A
A
and .
7
A
and carry out the
3
A
B