Towing A Trailer - Skoda 2011 Yeti Owner's Manual

Towing a trailer

Towing a trailer
Technical requirements
Your vehicle is designed primarily for transporting persons and luggage. It can,
however, also be used for towing a trailer - provided certain technical equipment is
fitted.
If your vehicle has been factory-fitted with a towing device or has a towing device
from Škoda Original Accessories, then the towing device satisfies all technical and
legal requirements.
Your vehicle is fitted with a 13-pin power socket for the electrical connection
between the vehicle and trailer. If the trailer which you wish to tow has a 7-pin
connector, you can use a suitable adapter from Škoda original accessories.
This work must be carried out in accordance with the manufacturer's specifications
if a towing device is retrofitted.
Authorised Škoda Service Partners can provide detailed information about retrofit-
ting a towing device and for any necessary modifications to the cooling system.
WARNING
We recommend that you have the towing device from Škoda original accessories
installed by an authorised Škoda Service Partner. He is familiar with all the rele-
vant details relating to retrofitting such equipment. There is a risk of an accident
if the towing device is not properly fitted!
General Maintenance
Trailer load
The permissible trailer load must on no account be exceeded.
You can negotiate appropriately steeper inclines and descents if you do not make
full use of the permissible trailer load.
The trailer loads specified only apply for altitudes up to 1000 metres above mean
sea level. The fact that the engine power output drops with increasing height due
to a lowering of air pressure and thus the ability to climb, means that the towed
weight must be reduced by 10 % for every further increase of 1 000 metres in height
above sea level. The towed weight is the weight of the (laden) vehicle and the
Using the system Safety
(laden) trailer together. One should take this into account before driving up to
higher altitudes.
The trailer and drawbar load information on the type plate of the towing device
are merely test data for the towing device The data relating to your vehicle, which
is often less than this test data, can be found in your vehicle registration docu-
ments.
Distribution of the load
Distribute the load in the trailer in such a way that any heavy items are located as
close as possible to the axle. Secure the items to prevent them slipping.
Tyre pressure
Correct the tyre inflation pressure on your vehicle for that of "fully laden"
 page 205. The inflation pressure of the tyres fitted to the trailer adjust in accord-
ance with the manufacturer's recommendation.
Exterior mirrors
You have to have additional exterior mirrors fitted if you are not able to see the
traffic behind the trailer with the standard rear-view mirrors. Both exterior mirrors
should be attached to folding arms. Adjust the mirrors so that they provide you with
an adequate field of view to the rear.
Headlights
Before starting off with a hitched trailer, also check the setting of the headlights.
Alter the setting as necessary with the aid of the headlight beam adjuster
 page 54.
Detachable ball head
The ball rod is detachable on vehicles with towing device and suppliable from Škoda
original accessories. It is stowed together with separate fitting instructions in the
spare wheel well in the luggage compartment of the vehicle.

intervals if you tow a trailer frequently.

pling the trailer.
Driving Tips General Maintenance
Note
We recommend that you also have your vehicle inspected between service
The handbrake on the towing vehicle must be put on when coupling and decou-
Breakdown assistance
Towing a trailer 183
Technical data