Skoda 2011 Yeti Owner's Manual page 54

Fog lights with the function "CORNER"
The fog lights with the function "CORNER" are designed for a better
illumination of the surrounding area near the vehicle when corning,
parking etc.
The fog lights with the function "CORNER" are adjusted according to the steering
angle or after switching on the turn signal light

the vehicle is stationary and the engine is running or it moves with a speed of
maximum 40 km/h;

the daylight driving lights are not switched on;

the low beam is switched on or the light switch is in the position
intensity of the ambient light causes the low beam to be switched on;

the fog lights are not switched on;

no reverse gear is engaged.
Note
If you engage the reverse gear during the active function "CORNER", both fog lights
illuminate.
Rear fog light 
Switching on the rear fog light
– First of all turn the light switch into position
– Pull the switch into position
The warning light  lights up in the instrument cluster when the rear fog light is
switched on  page 26.
Only the rear fog light of the trailer lights up if the vehicle has a factory-fitted
towing device or a towing device from Škoda original accessories and when you
are towing a trailer which is fitted with the rear fog light.
The rear fog light is located in the rear light array on the driver's side.
7)
If both switch on versions are conflicting, for example if the steering wheel is turned to the
left and the right turn signal light is switched on, the turn signal light has the higher priority.
Using the system Safety
7)
in the following circumstances:
 or   page 52, fig.
A
.
2
Driving Tips
Caution
The rear fog light should only be switched on if visibility is particularly poor (conform
with any varying legal provisions) to avoid dazzling vehicles behind your vehicle.
Instrument lighting
You can adjust the brightness of the instrument lighting.
 and the
Instrument lighting
– Switch on the light.
– Turn the control dial
The illumination intensity of the Information display  page 22 is set automatically.
39.
It is only possible to adjust the instrument lighting with the control dial if the light
intensity drops below the set value of the light sensor.
General Maintenance
Lights and Visibility

Fig. 40 Dash panel: Instrument lighting
 fig. 40 to the desired intensity of the instrument lighting.
Breakdown assistance
53
Technical data