Skoda 2011 Yeti Owner's Manual page 32

Hide thumbs Also See for 2011 Yeti:
Table of Contents

Advertisement

WARNING (continued)
Take care when opening the coolant expansion bottle. If the engine is hot,
the cooling system is pressurized - risk of scalding! It is best to allow the engine
to cool down before removing the cap.
Do not touch the coolant fan The coolant fan may switch on automatically
even if the ignition is off.
Traction control system (TCS)
The warning light
comes on for a few seconds when the ignition is switched on.
The warning light comes on when driving when a control cycle is activated.
The warning light lights up permanently if there is a fault in the TCS system.
The fact that the TCS system operates together with the ABS means that the TCS
warning light will also come on if the ABS system is not operating properly.
If the warning light
comes on immediately after starting the engine, the TCS
system can be switched off for technical reasons. In this case, the TCS system can
be switched on again by switching the ignition on and off. If the warning light goes
out, the TCS system is fully functional again.
Further information about the TCS  page 160, "Traction control system (TCS)".
Note
If the battery has been disconnected and reconnected, the warning light
on after switching on the ignition. The warning light must go out after driving a
short distance.
Anti-spin regulation (ASR)
The TCS system is switched off by pressing the button
warning light
lights up.
Electronic stability programme (ESP)
The warning light
comes on for a few seconds when the ignition is switched on.
When the ESP helps to stabilise the vehicle, the warning light
instrument cluster.
The warning light lights up permanently if there is a fault in the ESP system.
Using the system
Safety
 page 160, fig. 151
flashes in the
Driving Tips
The fact that the ESP system operates together with the ABS means that the ESP
warning light will also come on if the ABS system is not operating properly.
If the warning light
system can be switched off for technical reasons. In this case, the ESP system can
be switched on again by switching the ignition on and off. If the warning light goes
out, the ESP system is fully functional again.
Further information on the ESP  page 159, "Electronic stability programme (ESP)".
Electronic Differential Lock (EDL)
The EDL is a part of the ESP. A fault in the EDL is indicated by the lighting up of the
ESP warning light in the instrument cluster. Have the vehicle inspected immediately
by your specialist garage. Further information on the EDL  page 160, "Electronic
Differential Lock (EDL)".
Note
If the battery has been disconnected and reconnected, the warning light
on after switching on the ignition. The warning light must go out after driving a
short distance.
Selector lever lock
If the green warning light
in order to be able to move the selector lever out of the position P or N.
Further information about the selector lever lock  page 118.
comes
Tyre inflation pressure
The warning light
one of the tyres. Reduce the speed and check or correct as soon as possible the
inflation pressure in the tyres  page 205.
and the
An audible signal sounds as an additional warning signal.
If the warning light flashes, there is a system fault. Visit the nearest specialist
garage and have the fault rectified.
Further information about the tyre pressure monitoring system  page 164.
General Maintenance
Instruments and warning lights
comes on immediately after starting the engine, the ESP
lights up, operate the brake pedal. This is necessary,
lights up, if there is a substantial drop in inflation pressure in
Breakdown assistance
31
comes
Technical data

Advertisement

Table of Contents
loading

Table of Contents