Skoda 2011 Yeti Owner's Manual page 217

216 Breakdown assistance
Installing
– First press the full wheel trim onto the wheel at the valve opening provided.
Then press the full wheel trim into the wheel in such a way that its entire
circumference locks correctly in place.
Caution

Use the pressure of your hand, do not knock on the full wheel trim! Heavy
knocks mainly on the points where the full wheel trim has not been inserted into
the wheel, can result in damage to the guide and centering elements of the full
wheel trim.

Check for yourself that the safety wheel bolt is located in the hole in the area of
the valve before fitting the full wheel trim onto a steel wheel which is attached with
a safety wheel bolt  page 217.
Wheel bolts with caps
Pulling off
– Push the plastic clip sufficiently far onto the cap until the inner catches of the
clip are positioned at the collar of the cap and detach the cap.
Installing
– Push the caps fully onto the wheel bolts.
The caps are located in the well of the luggage compartment.
Fig. 179 Removing the cap.
Wheel trim caps
Pulling off
– Carefully remove the wheel trim cap using the wire clamp
Slackening and tightening wheel bolts
Slacken the wheel bolts before jacking up the vehicle.
Slackening wheel bolts
– Insert the wheel wrench fully onto the wheel bolt
– Grasp the end of the wrench and turn the bolt about one turn to the left
 fig. 181.
16)
Use the appropriate adapter for slackening and tightening the safety wheel bolts  page 217.
Fig. 180 Pulling off wheel trim cap on
light alloy wheels
 fig.
180.
Fig. 181 Changing a wheel: Slackening
wheel bolts
16)
.