Auto Check Control - Skoda 2011 Yeti Owner's Manual

24 Instruments and warning lights

Auto Check Control

Car state
The Auto Check Control carries out a check of certain functions and vehicle compo-
nents. The check is performed constantly when the ignition is switched on, both
when the vehicle is stationary, as well as when driving.
Some operational faults, urgent repairs, service work or other information appear in
the display of the instrument cluster. The displays are shown with a red or yellow
light symbol depending on the priority of the message.
The red symbols indicate danger (priority 1) while the yellow symbols indicate a
warning (priortity 2). Information for the driver may also appear in addition to the
symbols  page 26.
There is at least one error message when the term Vehicle status is displayed in the
menu. After selecting this menu the first of the error messages is displayed. Several
error messages are shown on the display under the message e.g. 1/3. This indicates
that the first of a total of three error messages is displayed. Investigate the
displayed faults as soon as possible.
As long as the operational faults are not rectified, the symbols are always indicated
again. After the first display, the symbols are indicated without information for the
driver.
If a fault occurs, a warning signal will also sound in addition to the symbol and text
in the display:

Priority 1 - three warning signals

Priority 2 - one warning signal
Red symbols
A red symbol signals danger.
– Bring the vehicle to a stop.
– Switch the engine off.
– Investigate the function indicated.
– Obtain professional assistance.
Meaning of the red symbols:

Engine oil pressure too low
Overheated clutches of the automatic gear-

box DSG
Three successive warning signals will sound if a red symbol appears.
Yellow symbols
A yellow symbol signals a warning.
Check the relevant function as soon as possible.
The meaning of the yellow symbols:
Check engine oil level,

engine oil sensor faulty
It is also important to have the vehicle inspected
Problem with
without delay by a specialist garage. The informa-

engine oil pres-
tion about the maximum permissible engine speed
sure
In certain countries, if a yellow symbol appears one warning signal will sound as
well.
If several operational faults of priority 2 exist, the symbols appear one after the
other and are each illuminated for about 5 seconds.
Set-up
You can change certain settings by means of the information display. The current
setting is shown on the information display in the respective menu at the top below
the line.
You can select the following information (depending on the equipment installed on
the vehicle):

Language

MFD Data

Convenience

Lights & Vision

Time
 page 29
 page 34
 page 196
is displayed together with this symbol.