Warning Lights; Auto-Check Control - Skoda Octavia Owner's Manual

Resetting Service Interval Display
If the variable service interval is set in your vehicle and if the service interval dis-
play is reset, the variable service interval is switched to the fixed service interval.
Only the "Oil Change Service" indication is reset, the "Inspection" indication is not
reset.
We therefore recommend that the Service Interval Display be reset only by a
ŠKODA Partner, who will reset the display with a vehicle system tester.
The ŠKODA Partner will carry out the following steps.
›
He resets the display memory after the relevant inspection.
›
He makes an entry in the service schedule.
›
He affixes a sticker with the entry of the following service interval to the side of
the dash panel on the driver's side.
The reset can be done with the button
›
Switch off the ignition (for vehicles with the KESSY system, also close the driv-
er's door).
›
Press the button and keep it pressed down.
6
›
Switch on the ignition.
›
Release and then press again the button
CAUTION
We recommend that you do not reset the service interval display yourself. Incor-
rectly setting the service interval display could cause problems to the vehicle.
Note
Information is retained in the Service Interval Display even after the vehicle bat-
■
tery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must be
■
entered in the counter for the Service Interval Display. We recommend having this
work undertaken by a ŠKODA Partner.
For more information on the service intervals
■
ice intervals.
12
Using the system
» Fig. 2 on page 8.
6
.
6
» service schedule, chapter serv-

Auto-check control


First read and observe the introductory information and safety warn-
ings on page 8.
Certain functions and conditions of individual vehicle systems are checked contin-
uously when the ignition is switched on.
Error messages and/or other information are displayed in the instrument cluster
display.
Some messages are displayed simultaneously with the warning lights
or warning icons in the display
While the operational faults remain unrectified, the messages are always indica-
ted again. After they are displayed for the first time, the symbols
to be indicated without any extra messages for the driver.
Symbol


WARNING
If you have to stop for technical reasons, then park the vehicle at a safe dis-
tance from the traffic, switch off the engine and activate the hazard warning
light system » page 53. The warning triangle must be set up at the prescri-
bed distance - observe the national legal provisions when doing so.

Warning lights


Introduction

This chapter contains information on the following subjects:
Clutches of the automatic gearbox too hot

Handbrake

Brake system

Front seat belt warning light

Power steering
 
Traction control system (TCS)

» page 18.

Description
Warning
Danger
» page 12
or continue


13
13
14
14
14
14
