Configuring Snmp Queries And Traps - Fortinet fortivoice Administrator's Manual

Configuring SNMP queries and traps

Go to System > Configuration > SNMP to configure SNMP to monitor FortiVoice system events
and thresholds, or a high availability (HA) configuration for failover messages.
To monitor FortiVoice system information and receive FortiVoice traps, you must compile
Fortinet proprietary MIBs as well as Fortinet-supported standard MIBs into your SNMP
manager. RFC support includes support for most of
RFC 1213
The FortiVoice SNMP implementation is read-only. SNMP v1, v2c, and v3 compliant SNMP
managers have read-only access to FortiVoice system information and can receive FortiVoice
traps.
The FortiVoice SNMP v3 implementation includes support for queries, traps, authentication, and
privacy. Before you can use its SNMP queries, you must enable SNMP access on the network
interfaces that SNMP managers will use to access the FortiVoice unit. For more information, see
"Editing network interfaces" on page
This topic includes:
• Configuring an SNMP threshold
• Configuring email settings
• Configuring an SNMP v3 user
Configuring an SNMP threshold
Configure under what circumstances an event is triggered.
To set SNMP thresholds
1. Go System > Configuration > SNMP.
2. Configure the following:
Fortinet Technologies Inc.
(MIB II). For more information, see
RFC 2665
"FortiVoice MIBs" on page
41.
Page 78 FortiVoice Enterprise Phone System 4.0.0 Administration Guide
(Ethernet-like MIB) and most of
82.