Example: Failover Scenarios - Fortinet fortivoice Administrator's Manual

GUI item
Timeout
Interval
Retries
6. For SIP UDP, configure the following:
GUI item
Enable
Name
Remote IP
Port
Timeout
Interval
Retries
7. For Interface monitor and Local hard drives, configure the following:
GUI item
Enable
Interval
Retries

Example: Failover scenarios

This section describes basic FortiVoice active-passive HA failover scenarios. For each scenario,
refer to the HA group shown in
following abbreviations are used:
• P1 is the configured primary unit.
• S2 is the configured secondary unit.
Fortinet Technologies Inc.
Description
Enter the timeout period for one connection test.
Enter the frequency of the tests.
Enter the number of consecutively failed tests that are allowed before the
primary unit is deemed unresponsive and a failover occurs.
Description
Select to enable SIP UDP service.
Displays the service name.
Enter the peer IP address.
Enter the port number of the peer SIP UDP service.
Enter the timeout period for one connection test.
Enter the frequency of the tests.
Enter the number of consecutively failed tests that are allowed before the
primary unit is deemed unresponsive and a failover occurs.
Description
Select to enable local hard drive monitoring. Interface monitoring is enabled
when you configure interface monitoring. See
monitoring" on page 63.
Network interface monitoring tests all active network interfaces whose:
• "Virtual IP action" setting is not Ignore
• "Configuring interface monitoring"
For details, see "Configuring interface monitoring" on page 63
IP action" on page 66.
Enter the frequency of the test.
Specify the number of consecutively failed tests that are allowed before the
local interface or hard drive is deemed unresponsive and a failover occurs.
Figure 23. To simplify the descriptions of these scenarios, the
Page 67
"Configuring interface
setting is enabled
FortiVoice Enterprise Phone System 4.0.0 Administration Guide
and "Virtual