Panasonic KX-TDA100 Programming Manual page 284

2.7 [1] Configuration
CO Pulse Speed
Selects the speed at which pulse dials are sent to the E & M line.
Value Range
10 pulse/s, 20 pulse/s
Maintenance Console Location
2.7.28 [1-1] Slot—E&M Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
1.5.4.4 Dial Type Selection
Wink Signal Time Out
Specifies the length of time that the PBX waits to receive a wink signal after seizing a trunk. If a wink
signal is not received before this timer expires, the trunk is released.
Value Range
64 × n (n=1–128) ms
Maintenance Console Location
2.7.28 [1-1] Slot—E&M Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Guide References
None
Start Signal Type
Selects the type of the start signal.
Value Range
Immediate: Sends the dialled digits to the trunk when the First Dial Timer expires.
Wink: Sends the dialled digits to the trunk when the wink signal is received.
Maintenance Console Location
2.7.28 [1-1] Slot—E&M Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
284 PC Programming Manual