Panasonic KX-TDA100 Programming Manual page 19

4. Enter the Installer Level Programmer Code (default:
INSTALLER).
The Programmer Code authorises different programming
levels, and the Quick Setup is only available when you start
the KX-TDA Maintenance Console with the Installer Level
Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorisation: Administrator Level (default: ADMIN),
and User Level (default: USER). (→ 1.2.2 Password
Security)
5. a.
Click the check box to connect to the Hybrid IP-PBX.
Options will appear as shown here, on the left.
b.
Enter the system password for installer (default:
1234).
c.
Select "USB", then click [OK].
Note
To connect to the Hybrid IP-PBX via USB, the KX-TDA
USB driver must be installed on the PC, as explained
above in "Installing the Maintenance Console".
6. When country/area data do not match:
a.
Click [OK] to replace the country/area data of the
PBX. Replacement may take several minutes to
complete.
b.
Follow the procedure described in Section 2.15.1
Starting the Hybrid IP-PBX (for KX-TDA600), Section
2.13.1 Starting the Hybrid IP-PBX (for KX-TDA100/
KX-TDA200) or 2.12.1 Starting the Hybrid IP-PBX (for
KX-TDA30) in the Installation Manual and restart the
PBX.
Click "Connect" → "USB" from the menu bar.
c.
d.
Repeat step 5 to restart the Maintenance Console.
7. Follow the instructions of the Quick Setup wizard and
assign the basic items.
1.2 PC Programming
PC Programming Manual 19