Advertisement
able to trigger the full blast warning, the full
blast warning will be triggered preferen-
tially. In this case, the pre-warning will not
be triggered.
When the system is disabled, it stays dis-
armed even if you perform any system
arming operation.
When the security system has been
already disarmed, you can switch the sys-
tem from the enabled state to the disabled
state, and vice versa, using the following
method.
1) Sit in the driver's seat and make sure
that all doors are closed, and then turn
the ignition switch to "ON" position or
press the engine switch to change the
ignition mode to ON.
• If any door is open, the open door
warning light comes on.
(1)
2) Turn the lock knob (1) on the driver's
door rearward (2). Turn the knob on the
lightning control lever to the OFF posi-
tion (3).
NOTE:
The following steps 3) and 4) must be
completed within 15 seconds.
(2)
3) Turn the knob on the lighting control
lever to the
back to the OFF position. Repeat this
operation 4 times.
64MS002
3 times
(4)
(3)
76MH0B004
(5)
4) Push the lock end (4) (forward end) of
the central door locking switch (5), and
4 times
OFF
76MH0B005
position and then turn
(6)
64MS024
Advertisement
