Advertisement
NOTE:
Even if you cannot close the window by the
auto-up feature because there may be
something wrong with the pinching preven-
tion function, you can close the window by
holding the window switch in the up posi-
tion.
If you drive in extreme off-road condition,
the pinching prevention function may oper-
ate accidentally because the window react
to vehicle jolting.
When you disconnect and re-connect the
battery or replace the fuse, the function will
be deactivated. In this condition, the auto-
down feature will be deactivated, while the
auto-up feature may remain being activated.
The pinching prevention function needs to
be initialized.
To initialize the pinching prevention func-
tion, use the following procedure:
1) Turn the ignition switch to the "ON"
position or press the engine switch to
change the ignition mode to "ON".
2) Open the driver's window fully by hold-
ing the window switch in the "DOWN"
position.
3) Close the driver's window by holding the
switch in the "UP" position, and keep
holding the switch for 2 seconds after the
window fully closed.
4) Check the driver's window if the auto-
down/up feature work.
If the auto-down/up feature would not work
after initialization, there might be some-
thing wrong with the pinching prevention
function. Have your vehicle inspected by
an
.
(2)
(2) Day driving
(3) Night driving
You can adjust the inside rearview mirror
by hand so as to see the rear of your vehi-
cle in the mirror. To adjust the mirror, set
the selector tab (1) to the day position,
then move the mirror up, down or sideways
by hand to obtain the best view.
68LMT0205
(1)
(3)
68LMT0206
Advertisement
