Advertisement
Select the BI-LVEL position (b) and "FRESH
AIR" position (f), the temperature selector to
the desired temperature position, and the
blower speed selector to the desired blower
speed position. Unless the temperature
selector is in the fully COLD position or fully
HOT position, the air that comes out of the
center and side outlets will be cooler than
the air that comes out of the floor outlets.
Set the air flow selector to the VENTILATION
position (a), the temperature selector to the
desired temperature position and the blower
speed selector to the desired blower speed
position, and push in the air conditioning
switch (5) to turn on the air conditioning sys-
tem. Setting the blower speed selector to a
higher blower speed position increases cool-
ing efficiency.
You can switch the air intake selector to
either the "FRESH AIR" position (f) or
RECIRCULATED AIR position (g) as you
desire. Choosing the RECIRCULATED AIR
position (g) increases cooling efficiency.
The control settings are the same as for
normal cooling except selecting the RECIR-
CULATED AIR position (g) and the highest
blower speed.
NOTE:
• If you select the recirculated air position
(g) for an extended period of time, the air
in the vehicle can become contaminated.
Therefore, you should occasionally select
the "FRESH AIR" position (f).
• If your vehicle has been left in the sun
with the windows closed, it will cool faster
if you open the windows briefly while you
operate the air conditioner with the air
intake selector at the "FRESH AIR" posi-
tion (f) and the blower at high speed.
Set the air flow selector to a desired air flow
selector position, the temperature selector
to the desired temperature position and the
blower speed selector to the desired blower
speed position. Also select the "FRESH
AIR" position (f) and push in the air condi-
tioning switch (5) to turn on the air condi-
tioning system.
NOTE:
Because the air conditioner dehumidifies
the air, turning it on will help keep the win-
dows clear, even when blowing heated air
using the DEFROST position (e) or HEAT &
DEFROST position (d).
NOTE:
If you need maximum defrosting:
• select the DEFROST position (e) and
"FRESH AIR" position (f),
• set the blower speed selector to HIGH,
64MS091
Advertisement
