Advertisement
To stow the key into the remote controller,
push the key in the remote controller until
you hear a click.
(A)
To remove the key from the remote control-
ler, push the button (A) in the direction of
the arrow and pull the key out from the
remote controller.
This exterior buzzer beeps for about 2 sec-
onds in the following conditions to warn you
that the request switch is not working:
• The request switch is pressed after all
doors are closed with the ignition mode
changed to "ACC" or "ON" by pressing
the engine switch.
• The request switch is pressed in any of
the following conditions after changing
the ignition mode to "LOCK" (OFF) by
pressing the engine switch.
57L21016
– The remote controller is left inside the
vehicle.
– Any door (including the tailgate) is
open.
Press the request switch again after doing
the following:
With the ignition mode changed to "LOCK"
(OFF) by pressing the engine switch, bring
out the remote controller if it is inside the
vehicle and check that all doors are com-
pletely closed.
68LM247
If the remote controller is not in the vehicle
under the following conditions, the buzzer
sounds intermittently for about 2 seconds
and the immobilizer/keyless push start sys-
tem warning light on the instrument cluster
blinks:
When one or more doors are opened and
all of the doors are later closed with the
ignition mode is other than "LOCK".
The indicator light will turn off within sev-
eral seconds after the remote controller is
returned to an area of the vehicle other
than the rear luggage area.
If the remote controller is left in the vehicle
and you lock the driver's door or front pas-
senger's door as described below, the door
will be automatically unlocked.
• If you open the driver's door and lock the
door by turning the lock knob forward or
pushing the power door locking switch,
64MS165
Advertisement
